9.111
Model 644E-42/944E-42 Rev. 6/04
Electrical System
Replace closed cab harness.
Not
OK
Blower motor inoperative at
any speed.
Check for voltage to wire
[BLB] (YEL/GRN) to
blower switch.
Check voltage at wires
[BLL] (YEL), [BLM] (RED)
and [BLH] (ORG) on 7 pin
blower connector. Check
wire [EVG] (BLK) for
proper ground.
Replace blower motor.
Check output voltage from
blower switch on wires
[BLL] (YEL) (L),
[BLM] (RED) (M) and
[BLH] (ORG) (H).
Replace switch.
If
OK
If OK
If OK
Not
OK
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating to
circuit are clean and tight.
3. All grounding straps are
intact and securely
fastened, refer to Section
9.1.12, “General Overview
(Vehicle Ground Strap
Locations).”
Comments to this Manuals