Lull 944E-42 Service Manual User Manual download pdf (Page 827)

100

101

11.25

Model 644E-42/944E-42 Rev. 6/04

Transfer Carriage

16. If the vehicle has dual batteries, connect both

negative battery cables (16 and 17) to both

batteries.

Connect the lower negative battery cable (16) to the

negative (-) terminal on the lower battery (18). Swing

the upper battery box (19) in and make sure that the

lip (20) on the upper battery box slides below the

knob (21). Secure in place with the knob (21).

17. Close and lock the engine compartment cover.

18. Inspect rear rollers. (Refer to Section 11.3.10, “Rear

Roller Gap Check.”)

19. If required, perform rear rollers shimming. (Refer to

Section 11.3.11, “Rear Roller Shimming.”)

11.3.17 Boom Pivot Bushing Replacement

1. Park the vehicle on firm level ground. Place the

travel select lever in the (N) NEUTRAL DETENT

position, engage the parking brake switch and raise

the boom to a horizontal (level) position.

2. Remove the boom as described in Section 3.3.3, a.

“Outer Boom Removal.”

Note: DO NOT apply any grease or anti-seize

compound to bushing or roller pin.

3. Inspect the boom pivot bushings (22). If they are

worn and visibly shake on the boom pivot pin, install

a new self-lubricating bushing (22) into the transfer

carriage (23).

4. Replace boom as described in Section 3.3.3, b.

“Outer Boom Installation.”

MU0650

MU3190

1 2 ... 822 823 824 825 826 827 828 829 830 831 832 ... 845 846

Comments to this Manuals

No comments

Lull 944E-42 Service Manual User Manual Page 827

Comments to this Manuals

Related products and manuals for Special machinery Lull 944E-42 Service Manual