Lull 944E-42 Service Manual User Manual download pdf (Page 819)

100

101

11.17

Model 644E-42/944E-42 Rev. 6/04

Transfer Carriage

11.3.11 Rear Roller Shimming

Note: The attachment should remain attached to the

quick attach.

1. Park the vehicle on firm level ground. Place the

travel select lever in the (N) NEUTRAL DETENT

position, engage the parking brake switch and raise

the boom to a horizontal (level) position.

2. Fully retract the boom and fully retract the transfer

carriage. Shut the vehicle OFF.

3. Lift the boom with a hoist to remove pressure off the

rear rollers. There should be a gap between the

rollers and the rails.

4. Move the transfer carriage so that the rear roller pin

can be removed through the hole in the side of the

frame.

5. Shut the engine OFF.

6. Place an Accident Prevention Tag on both the

ignition switch and steering wheel, stating that the

vehicle should not be operated. (Refer to Section

1.5, “Accident Prevention Tag Usage.”)

7. Open the engine compartment cover. Allow the

engine, transmission and hydraulic fluid to cool.

8. If the vehicle has dual batteries, disconnect both

negative battery cables (8 and 9) from both

batteries.

To access the lower battery (10), loosen the knob

(11) far enough so that the lip (12) on the upper

battery box clears the knob. Lift up the upper battery

box (13) and swing it out, so that the box clears the

hydraulic tank support bracket, to gain access to the

lower negative battery cable (8). Disconnect the

lower negative battery cable.

9. Remove locknuts (14), washers (15), Lull logo

plate (16) and black backing (17) from the rear of the

vehicle (18).

MU0650

MU1630

1 2 ... 814 815 816 817 818 819 820 821 822 823 824 ... 845 846

Comments to this Manuals

No comments

Lull 944E-42 Service Manual User Manual Page 819

Comments to this Manuals

Related products and manuals for Special machinery Lull 944E-42 Service Manual