Lull 944E-42 Service Manual User Manual download pdf (Page 830)

100

101

Transfer Carriage

11.28

Model 644E-42/944E-42 Rev. 6/04

13. Disconnect two hydraulic lines (1) connected to the

transfer cylinder (2). Plug, cap and label the hoses

and fittings.

14. Remove two bolts (3) securing the transfer cylinder

to the vehicle.

15. Lift, lower and place the transfer cylinder on support

blocks on a firm level surface.

b. Transfer Cylinder Installation

1. Lift the transfer cylinder into position on the vehicle

chassis.

2. Replace two bolts (3) securing the transfer cylinder

to the frame.

3. Connect two hydraulic lines (1) to the transfer

cylinder (2) according to their previously marked

positions.

4. Move the transfer carriage 5' 8'' (172 cm) so that the

pin (4) connecting the transfer cylinder to the

transfer carriage is at a pin access hole (5) near the

rear of the cab.

IMPORTANT: Make sure the threaded hole, of the

transfer cylinder pin, is facing downward during

installation.

5. Connect the transfer cylinder (6) to the transfer

carriage mount (7) with the transfer cylinder pin (8)

securing it with retaining rings (9).

6. If the vehicle has dual batteries, connect both

negative battery cables (10 and 11) to both

batteries.

Connect the lower negative battery cable (10) to the

negative (-) terminal on the lower battery (12). Swing

the upper battery box (13) in and make sure that the

lip (14) on the upper battery box slides below the

knob (15). Secure in place with the knob (15).

WARNING: To avoid personal injury

and/or equipment damage, make sure the

cylinder is properly supported until it is

completely installed.

MU3370

MU3050

MU5490

1 2 ... 825 826 827 828 829 830 831 832 833 834 835 ... 845 846

Comments to this Manuals

No comments

Lull 944E-42 Service Manual User Manual Page 830

Comments to this Manuals

Related products and manuals for Special machinery Lull 944E-42 Service Manual