Lull 944E-42 Service Manual User Manual download pdf (Page 806)

100

101

Transfer Carriage

11.4

Model 644E-42/944E-42 Rev. 6/04

11.3.1 Transfer Carriage Removal

1. Level the vehicle, place the travel select lever in the

(N) NEUTRAL DETENT position, engage the

parking brake.

2. Move the transfer carriage 5' 8'' (172 cm) so that the

pin (1) connecting the transfer cylinder to the

transfer carriage is at a pin access hole (2) near the

rear of the cab.

3. Remove the top snap ring (3) from the transfer

carriage pin (1).

4. Temporarily tape the pin in place so it will not fall out

during the following procedure.

5. Move the transfer carriage all the way forward.

6. Remove the tape and the pin (1).

7. If you are replacing the pin, remove the bottom snap

ring (3).

8. Shut the engine OFF.

9. Place an Accident Prevention Tag on both the

ignition switch and steering wheel, stating that the

vehicle should not be operated. (Refer to Section

1.5, “Accident Prevention Tag Usage.”)

10. Open the engine compartment cover. Allow the

engine, transmission and hydraulic fluid to cool.

11. If the vehicle has dual batteries, disconnect both

negative battery cables (4 and 5) from both

batteries.

To access the lower battery (6), loosen the knob (7)

far enough so that the lip (8) on the upper battery box

clears the knob. Lift up the upper battery box (9) and

swing it out, so that the box clears the hydraulic tank

support bracket, to gain access to the lower negative

battery cable (4). Disconnect the lower negative

battery cable.

MU3050

MU5490

MU0650

1 2 ... 801 802 803 804 805 806 807 808 809 810 811 ... 845 846

Comments to this Manuals

No comments

Lull 944E-42 Service Manual User Manual Page 806

Comments to this Manuals

Related products and manuals for Special machinery Lull 944E-42 Service Manual