Lull 944E-42 Service Manual User Manual download pdf (Page 156)

100

101

Axles, Drive Shafts, Wheels, Tires and Brakes

5.10

Model 644E-42/944E-42 Rev. 6/04

Note: ALWAYS use new o-rings when servicing the

vehicle.

10. Uncap and install new o-rings into the steering and

brake line fittings (1). Lubricate the o-rings with clean

hydraulic oil.

11. Connect the steering and brake lines at their tube

connections on the chassis. Torque to 12-22 lb-ft

(17-31 Nm)

12. If reinstalling an axle previously removed from the

vehicle, position the driveshaft yoke on the axle

according to the alignment marks made earlier. If

installing a new axle, note the position of the

driveshaft yoke on the transmission. Align the

driveshaft yoke on the axle in the same plane as the

yoke on the transmission.

13. Install the wheel and tire assemblies. (Refer to

Section 5.5.4, “Installing Wheel and Tire Assembly

Onto Vehicle.”)

14. Carefully remove the jack, hoist or overhead crane

and sling supporting the axle.

15. Carefully raise the vehicle using a suitable jack or

hoist. Remove the supports from beneath the frame

and lower the vehicle to the ground.

16. Remove the blocks from the front and rear of both

tires on the other axle.

17. Check wheel end and hydraulic reservoir oil levels.

18. If the vehicle has dual batteries, connect both

negative battery cables (2 and 3) to both batteries.

Connect the lower negative battery cable (2) to the

negative (-) terminal on the lower battery (4). Swing

the upper battery box (5) in and make sure that the

lip (6) on the upper battery box slides below the

knob (7). Secure in place with the knob (7).

MU1470

MU0650

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 845 846

Comments to this Manuals

No comments

Lull 944E-42 Service Manual User Manual Page 156

Comments to this Manuals

Related products and manuals for Special machinery Lull 944E-42 Service Manual